Saké Comments - help needed please.

Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
help needed please.
06-29-2010, 12:21 PM
Post: #1
help needed please.
ok , can any one tell me how to remove the wheels of a g1 autobot car? im attempting to transfer a few wheels of a red alert onto a sideswipe ive picked up who is minus a few wheels. i dont want to damage the wheels or the pin thats in the middle. is it as simple as pull out the centre pin or does the pin connect to some where else inside. dont want to attempt it till i know for sure. :?

[Image: images-1.jpg]

IM NOT MAD, IM LOVEABLE!!
Find all posts by this user
Quote this message in a reply
06-29-2010, 04:47 PM
Post: #2
Re: help needed please.
Not a clue I'm afraid mate and haven't got one to check on.

[center][Image: kinggrimlock1.jpg][/center]
Find all posts by this user
Quote this message in a reply
06-29-2010, 05:42 PM
Post: #3
Re: help needed please.
Isn't that when you have to take a soldering iron to the pin to heat it up enough to pull it out?

If you're registered at TFW2005 check their Kitbash resource pages.

360 MiniCons and counting.
[Image: serious.jpg]
Click the pic to visit my site.
Knowledge is knowing a tomato is a fruit. Wisdom is not putting it in a fruit salad.
Visit this user's website Find all posts by this user
Quote this message in a reply
07-04-2010, 10:06 PM
Post: #4
Re: help needed please.
cant find nothing on TFW2005 phill. ill give the soldering iron a go tommorrow. if i can find it . my tool boxes need a good clean out. :oops:

[Image: images-1.jpg]

IM NOT MAD, IM LOVEABLE!!
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread:
5 Guest(s)

Return to TopReturn to Content